42V Input – 3.3V @ 2A Output High Voltage Step Down Regulator
The project described here is a high voltage step-down regulator based on A4447 general-purpose buck converter chip from Allegro Semiconductor. The output voltage of the board is configured at 3.3V, but it is adjustable from 0.8 to 24V, based on the resistor divider R2 and R5. Connector CN1 is for DC input 24V-42V, Connector CN2 is DC Output. Refer to the information below to adjust various voltage outputs.
42V Input – 3.3V @ 2A Output High Voltage Step Down Regulator – [Link]
View all comments
Join 97,426 other subscribers
Aaeon AI Arduino ARM Battery BLE Bluetooth camera DC-DC display ESP32 ESP8266 FPGA GPS I2C IoT Kickstarter LCD Led Linux Mcu MEMS Microchip Microcontroller MOSFET Motor OLED Oscilloscope PCB Power supply PWM Raspberry Pi regulator RISC-V SBC Sensor SOC SOM STMicroelectronics Switching temperature Texas Instruments TFT USB Wifi