Join the Community
Main Menu
Infineon Adds Post-Quantum Security to Quad-Motor Control MCUs
HPMicro HPM5100 MCU Series Brings 480 MHz RISC-V and 16-bit ADCs
What Is DECT NR+? Examining the New 5G Non-Cellular Mesh Standard
Microchip MTCH3380P and MTCH3240P Touch Controllers Offer Parallel Sensing
Polyimide Tape for PCB Masking: Avoiding Edge Lift and Residue
Prevent Post-Launch Application Failures with Real-World Network Simulation
The Approach to AI Infrastructure Is the Real Bubble
Mastering the Curve: Layout Strategies for FPC Bend Radius and Reliability
Single Pair Ethernet: One Twisted Pair, Full Ethernet Performance
Analog To Digital Conversion - Sampling and Quantization
Positive Feedback in Electronic Circuits
Temperature Sensors
High Current Half Bridge with Over-Current Shutdown
3-Wire Electret Microphone Pre-Amplifier
12W Step Up DC-DC Converter using MAX1771
Sound to Light Color Shield for OLEDUINO v2
An Introduction to RF Theory, Practices, and Components: The Ins and Outs of RF
The Growing Decentralization of Power Grids
Velleman Inc., a producer and a distributor of electronics, has produced a new handheld oscilloscope with the same power of its...
This circuit is based on LM2587, a simple boost converter from Texas instruments.
The circuit provided here is a transformer-less non-isolated power supply which is capable of delivering an output of 12V at...
Envox Experimental Zone (EEZ) is an open hardware and open source development website, that creates and shares various open...
When you travel, it’s a bit frustrating to fill your luggage with lots of chargers, cables, and adapters to fit your charging n...
The LTC2944 measures battery charge state, battery voltage, battery current and its own temperature in portable product...
A new challenge is posted on Elektor, for building a charger project for 3.6-V single-cell lithium iron phosphate (LiFePO4), a...
Rui Cabral tipped us with his latest video.
The circuit shown here is a step down converter which can convert an input voltage varying from 8V to 28V to 5V.
pinko @ blog.exrockets.com wanted to test some cheap load cells so he decided to build his own load cell amplifier.
pinko @ blog.exrockets.com wanted to regulate the power to a resistive load so he decided to build a PWM power regulator based on...
A lot of project are battery powered and some of them need dual battery links.
