Digital Pressure Gauge 0 to 10kPa (0 to 1.75 psi) with OLED display

Digital Pressure Gauge 0 to 10kPa (0 to 1.75 psi) with OLED display

The project presented here is a Digital Pressure Gauge using an OLED display. The measuring range of this unit is 0 to 10kPa (0 to 1.75 psi). Additional this compact open-source hardware is Arduino compatible. This board can be used for measuring low pressure up to 1.75psi with great...

Continue Reading
4.506
Views
0 Comments
Smart RGB LED Light Stick – Arduino Compatible

Smart RGB LED Light Stick – Arduino Compatible

This is a Smart LED light stick that contains 20 x WS2812B single wire addressable full colors RGB LEDs and Atmega328 microcontroller. These full colors chainable intelligent RGB LEDs work with a single wire addressable protocol thus they require a micro-controller to generate the...

Continue Reading
4.602
Views
3 Comments
RGB LED Controller using Atmega328

RGB LED Controller using Atmega328

This is a 3-channel, PWM based current-adjustable LED driver designed for RGB LED control. The circuit has been designed to control high current RGB LEDs or RGB LEDs strip. Colors of the three RGB LEDs can be set using 3 potentiometers, different colors are possible by adjusting these...

Continue Reading
4.575
Views
2 Comments
Current Meter Using 0.96″ OLED Display

Current Meter Using 0.96″ OLED Display

This project provides an economical and precise solution for DC current sensing and display on an OLED display. This board uses the ACS715T-20A hall effect-based linear current sensor chip, 0.96 Inch I2C OLED Display and Atmega328 microcontroller chip. It is an Arduino compatible...

Continue Reading
4.053
Views
0 Comments
Infrared Remote-Controlled AC Load ON/OFF switch with SSR

Infrared Remote-Controlled AC Load ON/OFF switch with SSR

Driving an AC high voltage and current load using an Infrared remote is very easy with this project. This is an open-source Arduino compatible hardware that is based on ATMEGA328 microcontroller, SSR (Solid-state Relay), Infrared Receiver TSOP1838, and analog input interface. We have...

Continue Reading
2.955
Views
0 Comments
Lead Acid Battery Voltage Monitor using ATMEGA328

Lead Acid Battery Voltage Monitor using ATMEGA328

Monitoring the voltage level of a 12V Lead Acid Battery (SLA) is easy and simple with this project. The board is made using an ATMEGA328 micro-controller and 12 x 5mm LEDs. The ATMEGA328 microcontroller senses the analog voltage on A3 Analog pin and drives 12 LEDs connected to digital...

Continue Reading
4.103
Views
0 Comments
Brushed DC Motor Speed and Direction Controller Using Joystick

Brushed DC Motor Speed and Direction Controller Using Joystick

This DC Motor controller provides direction and speed control of a brushed DC motor using a Joystick. This is an Arduino compatible open-source hardware with various applications. It can be used to control scissor lift motor, Linear actuator, Camera slider, camera pan-tilt head,...

Continue Reading
5.664
Views
0 Comments
Brushed DC Motor Controller Using Infra-Red Remote  

Brushed DC Motor Controller Using Infra-Red Remote  

This project enables the user to control a Brushed DC Motor using an Infra-Red Remote Control, thus controlling speed, direction, and also brake of DC Motor is possible. It's an Arduino compatible open-source hardware that helps you develop many DC Motor control applications. The user...

Continue Reading
4.356
Views
0 Comments
Archives