TinyOLEDdemo – I²C OLED on an ATtiny10, ATtiny13A or ATtiny202
https://www.electronics-lab.com/tinyoleddemo-i%c2%b2c-oled-on-an-attiny10-attiny13a-or-attiny202/
This is just a little demo on how to use an I²C OLED with the limited capabilities of an ATtiny10, ATtiny13A or ATtiny202 from Stefan Wagner @ github.com Connect the OLED module to the ATtiny13A as shown below. The connections for the ATtiny10 are similar. For the ATtiny202 SDA must be connected to PA1 (pin […]
An Introduction: LCD Common Interfaces
https://www.electronics-lab.com/an-introduction-lcd-common-interfaces/
There are a lot of different LCD display interfaces depending on the requirements of resolutions, speed, cost, stability etc. The following outlines the common ones on the market: Parallel vs Serial Interface Parallel interface could transmit many data bits at the same time depending on the data bits width. PROs: Simple CONs: Need RAM, Speed […]
IIS2ICLX 2-Axis Digital Inclinometer
https://www.electronics-lab.com/iis2iclx-2-axis-digital-inclinometer/
STMicroelectronics’ high-accuracy and low-power two-axis linear accelerometer includes digital output. The STMicroelectronics IIS2ICLX is a high-accuracy (ultra-low noise, high stability and repeatability) and low-power two-axis linear accelerometer with digital output. The IIS2ICLX has a selectable full scale of ±0.5/±1/±2/±3 g and is capable of providing the measured accelerations to the application over an I²C or […]
Free Elektor Article: Card Sound
https://www.electronics-lab.com/free-elektor-article-card-sound/
With a smartphone or an MP3 player it’s easy to play audio files, but generally not at room strength or if you can, only in wretched quality. The Card Sound project makes it possible to fill the room with music and have excellent sound reproduction! This lightweight and compact player also stands out for its […]
I²CMini – A tiny USB to I²C bridge that is compatible with I²CDriver
https://www.electronics-lab.com/i%c2%b2cmini-tiny-usb-i%c2%b2c-bridge-compatible-i%c2%b2cdriver/
I²CMini is a USB to I²C bridge. It can drive and monitor I²C traffic and measures just 18 mm square. It has a micro USB connector, a Qwiic connector on the I²C side, and .1″ pins for a breadboard or pin header. I²CMini is 100% compatible with I²CDriver, and like I²CDriver (i2cdriver.com) it’s an easy-to-use, […]
Digital 16bit Serial Output Type Color Sensor IC – BH1749NUC
https://www.electronics-lab.com/digital-16bit-serial-output-type-color-sensor-ic-bh1749nuc/
ROHM’s BH1749NUC is a digital color sensor IC with I²C bus interface. This IC senses Red, Green, Blue (RGB) and Infrared and converts them to digital values. The high sensitivity, wide dynamic range and excellent Ircut characteristics make it possible for this IC to obtain the accurate illuminance and color temperature of ambient light. It […]