DC Solid State Power Relay with Current Feedback

DC Solid State Power Relay with Current Feedback

Optically Coupled Power MOSFET Relay with Galvanically Isolated Current Monitor Output This project employs CPC1718J 100V Single-Pole, Normally Open DC-Only Power Relay and ACS71240 Galvanically Isolated Current Sensor IC with Common-Mode Field Rejection and Overcurrent Detection....

Continue Reading
1.468
Views
0 Comments
Dual MOSFET Driver – Two Channel DC SSR Using MOSFETS & Gate Driver

Dual MOSFET Driver – Two Channel DC SSR Using MOSFETS & Gate Driver

The project presented here is a dual-channel MOSFET DC relay. The project is capable of driving a 5A load on each channel with an input supply of 48V DC. The LTC7067 chip drives the two high-side N-Channel MOSFETS with supply voltages up to 48V DC. Its powerful 0.8Ω pull-down and...

Continue Reading
1.751
Views
0 Comments
Low Profile 2 Channel Solid State Relay for AC Loads

Low Profile 2 Channel Solid State Relay for AC Loads

This project offers an extremely compact solution for interfacing 2 high voltage resistive or inductive loads. At a low profile, this is the most compact & versatile optically isolated 2 channel solid state relay system. The circuit consists of 2x Triacs and isolated Triac...

Continue Reading
2.968
Views
0 Comments
Arduino Nano- Switching ON/OFF Appliances Using Infra-Red Remote (Two Channel)

Arduino Nano- Switching ON/OFF Appliances Using Infra-Red Remote (Two Channel)

The project presented here is a two-channel infrared remote ON/OFF switch that can be used to control home appliances, Lights, Fans, Water Pumps, Aquarium pumps, Ovens, Heaters, etc. This open-source project contains 2 x SSR (Solid State Relay), Arduino Nano, and TSOP1838 infrared...

Continue Reading
3.691
Views
0 Comments
Infrared Remote-Controlled AC Load ON/OFF switch with SSR

Infrared Remote-Controlled AC Load ON/OFF switch with SSR

Driving an AC high voltage and current load using an Infrared remote is very easy with this project. This is an open-source Arduino compatible hardware that is based on ATMEGA328 microcontroller, SSR (Solid-state Relay), Infrared Receiver TSOP1838, and analog input interface. We have...

Continue Reading
3.257
Views
0 Comments
DC Output Solid State Relay

DC Output Solid State Relay

DC Output Solid State Relay 10Amps 60V DC (Optically Isolated Input) This project has been designed around TLP250/352 which is Opto-Coupler IGBT/MOSFET Gate Driver from Toshiba and Mosfet IRFP260 from IR, This relay consists of optically isolated gate driver and low impedance...

Continue Reading
48.335
Views
12 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives