Projects Projects
6 Digit Serial Display Driver with CAT4016
6 Digit serial display project has been designed around CAT4016 IC from ON semi.
USB to UART Converter with GPIO – MCP220
The Module is based on The MCP2200, which is a USB-to-UART serial converter which enables USB connectivity in application that have a UART interface.
DS1307 RTC SMD Module
The module based on DS1307, The DS1307 serial real-time clock (RTC) is a low-power, full binary-coded decimal (BCD) clock/calendar plus 56 bytes of NV SRAM.
3W Stereo Audio Amplifier using TDA7266D
Tiny stereo audio amplifier board has been designed around SMD TDA7266D IC from ST.
13.8V 2A Power Supply using LM338
Introduction This power supply appeared in the summer issue of Elektor 2000 without a PCB layout.
Dual DC Motor Driver For Robot with L298
Dual Motor L298 H-Bridge Control project can control two DC motors connected to it.
PIC16F628A Programmable Digital Timer
Programmable relays find use in numerous automation applications such as automatic street light control, watering and pump control, HVAC, home automation, power plants automation in industries, etc.
Half Bridge Driver based on IR2104
This Half-bridge driver based on IR2104 gate driver IC and N channel Dpak MOSFET , The IR2104 is a high voltage, high speed power MOSFET driver with independent high and low side referenced output channels.
Over Current Protection Switch
Current Sensing Switch is designed to operate a Relay Contact when there is a DC current through the sense resistor exceeds the set point, Set point adjustable from 1A to 3Amp using on board potentiometer.
3.3V @ 1.5A Buck Regulator
The circuit presented here is based on LTC3601, a high efficiency, monolithic synchronous buck regulator from Linear Technology.
AmpStrike – Battery Powered Bench Power Supply
Introduction This is a small bench power supply that is powered by two lithium-ion batteries.
5V to 12V Step Up DC-DC Converter
Step up DC-DC converter is based on LM2577-ADJ IC, this project provides 12V output using 5V input, maximum output load of 800mA.