Projects Projects
Active Rectifier Controller with Reverse Protection for Battery and Solar cell
This demonstration circuit is an active rectifier with reverse protection for batteries in automotive applications.
Low Profile 2 Channel Solid State Relay for AC Loads
This project offers an extremely compact solution for interfacing 2 high voltage resistive or inductive loads.
TINY DC-DC Power Module – Input 8-28V DC – Output 5V DC 1A
This tiny power module is an easy-to-use integrated power solution that combines a 3A DC/DC converter chip with inbuilt power MOSFETs, an inductor, and passives into a 3-pin, through-hole package.
Automatic LED Stairway Lighting – Arduino Compatible
This creative idea is suitable for a stairway with 16 stairs, each stair can have a 12V LED.
Programmable Frequency – Continuous Conduction Mode (CCM) – Boost Power – Factor Correction (PFC) Controller
The circuit described here is a simple PFC controller using the UCC28180 chip from Texas instruments.
SafeBee – A GPS Tracker for Beehives
This is an original design of a GPS tracker designed on Elab and it is intended to be used as a security device for beehives, but it is not limited to this.
3 Phase Isolated Hall-effect Current Sense Amplifier with +/-600V Working Voltage and +/-46A Measurement Range
The project described here is a 3-Phase isolated Hall-effect current sense amplifier with +/-600-V working voltage range.
Multiphase Oscillator with 40% Spread Spectrum Frequency Modulation and 250Khz Output Frequency
This is a precision, low power, and easy-to-use oscillator that provides multiphase outputs.
Dual-Level Float-Cum-Boost Charger with Pre-Charge for 12V – 3 to 6Ah Sealed Lead Acid (SLA) Batteries
This SLA Battery charger project is the right choice if you want to obtain maximum battery service life and capacity, along with acceptable recharge time and economy, constant current, constant voltage, and even charge a deeply discharged battery.
15V to 60V – Three-Phase Brushless DC Motor Pre-Driver
The project presented here is a three-phase BLDC motor pre-driver.
Sensorless FOC 3 Phase Low Power Brushless BLDC Motor Driver
Driving a 3-phase brushless DC motor is very easy with this project.
Low Voltage Lead Acid Battery Disconnect board – Prevents Deep Discharge Of 12V Lead Acid Battery
This project helps to optimize the 12V lead-acid (SLA) battery life as it prevents the battery from going into deep discharge.