Projects Projects
Over Current Protection Switch
Current Sensing Switch is designed to operate a Relay Contact when there is a DC current through the sense resistor exceeds the set point, Set point adjustable from 1A to 3Amp using on board potentiometer.
3.3V @ 1.5A Buck Regulator
The circuit presented here is based on LTC3601, a high efficiency, monolithic synchronous buck regulator from Linear Technology.
AmpStrike – Battery Powered Bench Power Supply
Introduction This is a small bench power supply that is powered by two lithium-ion batteries.
5V to 12V Step Up DC-DC Converter
Step up DC-DC converter is based on LM2577-ADJ IC, this project provides 12V output using 5V input, maximum output load of 800mA.
-5V @100mA Switched Capacitor Converter
The circuit diagram presented here is about a negative voltage regulator.
Dual DC Motor driver using two L293D
Dual DC Motor driver using two L293D IC.
AC Motor Speed Controller using U2008B
This is a low cost, current feedback phase control AC motor driver based on U2008 IC.
DC Motor Speed and Direction Controller using L293D
DC Motor Speed and direction controller project based on L293D H-Bridge and 555 Timer IC.
5V to 12V @400mA Boost Converter
The circuit presented here is about a boost converter based on LM2698.
1.2V to 37V Regulated Power Supply – 1.2A
This project provides a variable output power supply ranging from 1.2 to 37 V @ 1.5 A.
5V @3A Switching Power Supply
This circuit is about a buck regulator which can produce an output of 5V for a input voltage ranging from 7V to 40V.
4A Bipolar Stepper Motor Driver Based on LV8727E
The Project is based on LV8727E IC from ON Semiconductor.