Projects Projects
One Channel RF Remote Relay Switch
The project described here is one Channel RF remote receiver Relay board.
High-Voltage (180V) – High-Current (30mA) Operational Amplifier Module
This project provides a platform to evaluate the OPA462 high-voltage, high-current operational amplifier.
High Voltage 3-Phase Full-Wave PWM Brushless Motor Driver
The project presented here is a three-phase sinewave PWM driver for high-voltage brushless motors.
Over Current Alarm with 15 Segment Bar-Graph Display
This Bar-Graph Display provides a high visibility 15-Segment Bar-Graph display for current measurements.
Single-Channel Smart High-Side Power Switch with Programmable Current Limit
This is a single-channel, fully-protected, high-side power switch with programmable current-limit.
Isolated USB Repeater – USB2.0
The project presented here is a USB port-powered, USB 2.0 isolator that isolates the USB host and USB device.
12-95V Input – 5V Output – High Voltage DC-DC Buck Converter
This is a versatile synchronous buck DC/DC converter built using the LM5008 chip.
3 Phase IPM Module for Small Power AC Motor
This is a 3-Phase Inverter Driver project designed for Small Power AC Motors.
3 Phase Inverter for Low Power AC Motor
This is a 3-Phase Inverter Driver project designed for Low Power AC Motor.
2.1 Channel Audio Processor with Subwoofer Output
This board is an Audio Processor built using PT2033 chip audio processor designed for versatile applications.
2 Channel MOSFET Module
This is a low profile and small size two-channel MOSFET board that can drive loads up to 2 x 3A.
Thermal Mass Air Flow Sensor – Constant Temperature Anemometer
The CTA mode (Constant Temperature Anemometer) consists of a simple feedback circuit for temperature regulation of the heater on the flow sensor and, as flow speed changes the thermal energy loss by the heater changes.