Articles

Introduction In most of our previous tutorials concerning operational amplifiers, only one input was applied to either the...

Introduction In most of our previous tutorials related to operational amplifiers, the configurations were based on amplifiers...

Introduction In the previous tutorials, we talked about the inverting op-amp and non-inverting op-amp, we considered...

Introduction We have seen in the previous tutorial about Voltage Dividers and that the voltage division process is made possible...

Introduction This article will focus on an electronic transformation of circuits known as star-delta transform or Y-Δ transform, ...

Introduction The fundamental relation between the current, voltage, and resistance is known as Ohm’s law and is probably the most ...

Introduction As a general concept, the power describes the speed at which a certain amount of energy is released/transmitted by a...

Introduction The series behavior of the three elementary components of electronics has been detailed in our previous article...

Introductio The resistor (R), inductor (L), and capacitor (C) are the three elementary passive components of electronics.

Introduction Within a period of 10 years at the end of the 19th century, many technological achievements allowed to extend the...

Introduction Often, not only the amplitude of the signal is interesting to transform, such as amplifiers do, but also its phase.