Design of a Korg Nutube Amplifier
Karlwoodward @ www.rs-online.com/designspark is in the process of designing a “guitar pedal” for amplification and distortion using the Korg Nutube we featured earlier. The Part 1 of a series of articles goes through the basic aspects of tubes and valves, the pros and cons on using a Nutube valve as well as discussing about low gain and high source impedance. In Part 2 of the series he goes deeper by building a working prototype and making some measurements.
View all comments
Join 97,426 other subscribers
Aaeon AI Arduino Battery BLE Bluetooth camera DC-DC display ESP32 ESP8266 FPGA GPS I2C IoT Kickstarter LCD Led Linux Mcu MEMS Microchip Microcontroller MOSFET Motor OLED Oscilloscope PCB Power supply PWM Raspberry Pi regulator RISC-V SBC Sensor SOC SOM STMicroelectronics Switch Switching temperature Texas Instruments TFT USB Wifi