Blog
AVR Synth
Posted by admin on October 23rd, 2008
synth-diy.blogspot.com writes:
I decided to make JAREK ZIEMBICKI’s AVRSYN. But there were only the schematics and no board layout so I had to make my own. So I started laying it out on eagle but I got on a deadlock due to the fact that I didn’t want to make a double sided board. I would etch it myself and double sided boards are a BIG pain in the but (vias and such, alignment etc). So I made it on a perfboard. But before that, I decided that it should be made into discrete modules. One for the microchip, one for the D2A (an R2R resistor ladder type) , one for the midi interface, one for the power supply and one for the switch multiplexer.
AVR Synth Part 1 – [Link] – Part 2 – [Link] - Part 3 – [Link] - Part 4 – [Link] - Part 5 – [Link]
RSS
October 31st, 2008 at 5:01 pm
[...] AVR Synth via Electronics Lab Read more | Permalink | Comments | Read more articles in Arduino | Digg [...]
October 31st, 2008 at 5:02 pm
[...] AVR Synth via Electronics Lab Read more | Permalink | Comments | Read more articles in Arduino | Digg [...]
October 31st, 2008 at 5:07 pm
[...] DIY AVR Synth via Electronics Lab [...]
October 31st, 2008 at 6:02 pm
[...] AVR Synth via Electronics Lab Read more | Permalink | Comments | Read more articles in Arduino | Digg this! Posted by Jonah [...]
November 1st, 2008 at 4:27 am
[...] DIY AVR Synth via Electronics Lab [...]