Projects Projects
Space-Efficient 12V Boost DC-DC Regulator using LM2735X
This is a Step-up DC-DC converter that converts 3V to 5.5V input to 12V output for up to 200mA load current.
Isolated Analog Control with Potentiometer
This module is an Isolated Potentiometer featuring an LOC110 linear optocoupler (with 3750V isolation) and an isolated DC-DC converter, operating from a single 5V supply.
Push-Pull Voltage Mode PWM Controller
This project is a simple, low-voltage push-pull PWM controller using the TI LM5032 chip and two MOSFETs.
I2C Real-Time Clock module with DS3231M
This project uses the DS3231M I2C real-time clock (RTC) module for extremely accurate timekeeping.
Fault Protected High Side Switch
This project uses the LT1910 high-side switch to protect a load from over-current.
Boost Converter 5V DC Input – 12V DC Output
This project is a compact boost converter circuit that steps up a 5V to 12V DC output using the LM2733 regulator.
4 Channel Optically isolated board with DC-DC converter
This 4-channel optocoupler module uses PC817 chips and a DC-DC converter for electrical isolation.
Load Cell Amplifier HX711 for Weigh Scale and Strain Gauge Sensor
This load cell amplifier uses the HX711 24-bit ADC for weigh scales and control.
INA122 Single Supply Micropower Instrumentation Amplifier Module
This low-noise INA122 precision instrumentation amp is ideal for portable data acquisition.
High-Voltage Isolated Half-Bridge Driver (Up to 1kV)
A fully isolated 1kV half-bridge driver for high-voltage use.
Serial-Input, Voltage-Output, 16-Bit DAC
The MAX5541 is a 16-bit digital-to-analog converter (DAC).
Intelligent High-Side Switch with Current Monitor
This high-side switch handles loads up to 10A.