Blog

Dual Motor L298 H-Bridge Control project can control two DC motors connected to it.

This is a body thermometer using a thermistor sensor, Arduino and LCD display.

Johan wanted to shrink his Arduino based ISM radio node to fit in an AA battery compartment so AAduino was born.

Raj Bhatt shared another project with us.

Here is a nice build of a LUX meter using BH1750 sensor and a Nokia 5110 LCD.

This Half-bridge driver based on IR2104 gate driver IC and N channel Dpak MOSFET , The IR2104 is a high voltage, high speed power...

Current Sensing Switch is designed to operate a Relay Contact when there is a DC current through the sense resistor exceeds the...

The LT8391 is a synchronous 4-switch buck-boost LED controller that regulates LED current from input voltage above, below, or...

Step up DC-DC converter is based on LM2577-ADJ IC, this project provides 12V output using 5V input, maximum output load 800mA.

Dual DC Motor driver using two L293D IC.

This low cost current feedback phase control AC motor driver based on U2008 IC, The U2008B is designed as a phase control circuit...