Join the Community
Main Menu
Makerfabs nRF52840 Board Brings Bluetooth and UWB Tracking Together
Microchip Expands 10BASE-T1S Lineup With New Transceivers and Endpoints
Seeed XIAO 1.47-inch IPS Touch Display Packs BLE, IMU and MicroSD
MINIX N304-AI Mini PC Packs Intel Core 3 304 SoC and 24 TOPS AI
Polyimide Tape for PCB Masking: Avoiding Edge Lift and Residue
Prevent Post-Launch Application Failures with Real-World Network Simulation
The Approach to AI Infrastructure Is the Real Bubble
Mastering the Curve: Layout Strategies for FPC Bend Radius and Reliability
Single Pair Ethernet: One Twisted Pair, Full Ethernet Performance
Analog To Digital Conversion - Sampling and Quantization
Positive Feedback in Electronic Circuits
Temperature Sensors
High Current Half Bridge with Over-Current Shutdown
3-Wire Electret Microphone Pre-Amplifier
12W Step Up DC-DC Converter using MAX1771
Sound to Light Color Shield for OLEDUINO v2
An Introduction to RF Theory, Practices, and Components: The Ins and Outs of RF
The Growing Decentralization of Power Grids
This project describes how to get 12 analogue PWM outputs from an ATtiny85, so you can drive 12 LEDs with individual control over...
ATmega328, FT231X NerO – MCU 8-Bit AVR Embedded Evaluation Board.
Dilshan R Jayakody designed a BMP180 sensor module based on PIC18F2550 MCU to test out it’s performance.
This is another Arduino Nano shield which can drive a Brushed DC Motor in both directions with PWM signal for speed control and...
The powerful, tiny power monitor shield for your Arduino Nano.
David Johnson-Davies designed a GPS module that decodes the NMEA sentences on ATtiny841, and this also runs the I2C slave routine.
All the simplicity of the Arduino Uno plus extra I2C UART SPI ADC IO and PWM channels.
This is a 10x10mm USB-Uart converter with 2Mbps interface speed based on the cheap CN330.
This project describes a simple GPS module which you can interface to via I2C.
A small avrdude compatible AVR-ISP programmer based on the FTDI FT234X which only needs a standard micro USB cable.
Connect your Arduino via WebUSB with an web application circuit simulator.
As a new Linux user or even a window pro user, you will probably be familiar with the terminal or command prompt as known in...
