Category: Control
Temperature controlled Fan
Ahmad Al-Shalabi and Bassma Karbouj show us how to control a DC fan using easy to find components. The fan works when temperature reach into pre-specified threshold. The purpose of this project is creating a cooling system by controlling in a DC fan in a simple way without using...
Continue ReadingOne Channel Infra Red Remote Controller
One Channel Infra-Red Remote and receiver with onboard Relay provides normally open and normally closed output. The project based on PIC12F683 Microcontroller from Microchip , TSOP1738 used as Infra-Red receiver. Micro-controller decodes the RC5 serial data coming from TSOP1738 and...
Continue Reading4 Channel Relay Board
Quad Channel Relay Board is a simple and convenient way to interface 4 relays for switching application in your project. Features Input supply 12 VDC @ 170 mA Output four SPDT relay Relay specification 5 A @ 230 VAC Trigger level 2 ~ 5 VDC Berg pins for...
Continue ReadingDark Sensitive Switch – LED Light
Dark activated LED light is a simple project which operates a LED when the light falling on the LDR goes below a set point. The circuit is built using LM393 comparator, LDR as light sensor, preset (potentiometer) for sensitivity adjustment, transistor to drive the LED. The project...
Continue Reading16 Channel InfraRed remote controller
16 Channel Infra-Red remote controller is based on PIC16F73 Microcontroller from Microchip. The receiver part follows RC5 (Philips) Code Format. Tiny receiver provides 16 latch outputs or 8 Latch + 8 Momentary outputs by closing Jumper J1. All outputs are TTL and can drive Relay board...
Continue ReadingParallel Port Breakout board with Buffer for CNC & Routers
Parallel port I/O break out board designed for Hobby CNC, Routers and Motion controller , This Board is an easy solution to driver stepper Motor driver, AC Servo (with Step-DIR Driver) and DC servo (with Step-DIR Driver), The Board is compatible with various CNC software specially...
Continue ReadingAutoResetRRR – Automatically reset routers/cameras/servers
"bogdan" published a new project, a device able to automatically reset your router, camera or server. AutoResetRRR is a kind electronic frustration reducing device: it cuts the power periodically to devices that can go nuts (routers, net cams, servers), but it does give a heads up....
Continue ReadingOptically Isolated LPT Breakout Board for CNC & Routers
Optically isolated parallel port break out board designed for Hobby CNC, Routers and Motion controller, This Board is an easy solution to drive stepper Motor driver through PC parallel port, The Board is compatible with various CNC software specially made for LPT port data output....
Continue Reading