Waveshare UPS HAT (E) Holds Four 21700 Lithium batteries and it’s Compatible with Pi 5/4/3B+
Raspberry PiTop Stories

Waveshare UPS HAT (E) Holds Four 21700 Lithium batteries and it’s Compatible with Pi 5/4/3B+

Waveshare has recently announced UPS HAT (E), which can be used to provide backup power for Raspberry Pi 5/4B/3B+ in case of a power outage. The HAT supports four 21700 Lithium batteries and includes a battery fuel gauge IC for monitoring battery power. The board also has a USB-C port...

Continue Reading
1.214
Views
0 Comments
Lattice MachXO5D-NX FPGA Family: Enabling Hardware Security in Programmable FPGAs
FPGATop Stories

Lattice MachXO5D-NX FPGA Family: Enabling Hardware Security in Programmable FPGAs

Lattice Semiconductor has introduced the MachXO5D-NX FPGA family, which integrates a hardware root of trust (RoT) into low-power FPGAs to address security challenges. By combining on-chip Flash memory and hardware encryption, these FPGAs minimize code capture risks during load time. The...

Continue Reading
1.084
Views
0 Comments
Raspberry Pi Pico 2 Launches with RP2350 Microcontroller and Costs Only $5
Raspberry PiTop Stories

Raspberry Pi Pico 2 Launches with RP2350 Microcontroller and Costs Only $5

Raspberry Pi Foundation has just announced the launch of Raspberry Pi Pico 2, built around the RP2350 Microcontroller. The new board will feature dual Cortex-M33 or Hazard3 processors, increased SRAM and flash memory, and advanced security features like anti-fuse OTP for key storage,...

Continue Reading
1.277
Views
0 Comments
Recore A8 3D Printer Controller Board Features TMC2209 Stepper Motor Drivers
3D PrintingTop Stories

Recore A8 3D Printer Controller Board Features TMC2209 Stepper Motor Drivers

The Recore A8 is an all-in-one 3D printer control board with six built-in TMC2209 stepper motor drivers and support for two additional drivers. It features additional connectors for end-stops, Neopixels, servos, probes, and BLTouch(An auto-leveling sensor for 3D printers), on top of...

Continue Reading
1.179
Views
0 Comments
Radxa X4 Is a Raspberry Pi Sized SBC with Intel N100 Processor and 2.5GbE Ethernet
SBCTop Stories

Radxa X4 Is a Raspberry Pi Sized SBC with Intel N100 Processor and 2.5GbE Ethernet

Radxa X4 is an Intel Processor N100 powered single board computer(SBC) in a Raspberry Pi 5 form factor. The board offers almost the same features as a Raspberry Pi including dual mini HDMI output, USB, 40-pin GPIO, and LPDDR5 RAM options. But this board has much more than just copied...

Continue Reading
1.167
Views
0 Comments
RISC-V Based Lichee Pi 3A with 16GB RAM and PCIe Support
SBCTop Stories

RISC-V Based Lichee Pi 3A with 16GB RAM and PCIe Support

Sipeed has introduced the Lichee Pi 3A, an advanced development board designed for a wide range of computing tasks, including embedded systems and AI development. Powered by the K1 processor, a 22nm RISC-V 1.6GHz CPU with eight cores, the Lichee Pi 3A offers efficient performance for...

Continue Reading
1.270
Views
0 Comments
Meles RISC-V Credit Card-Sized SBC: Powered by T-Head TH1520 Quad-Core SoC
SBCTop Stories

Meles RISC-V Credit Card-Sized SBC: Powered by T-Head TH1520 Quad-Core SoC

Shenzhen Milk-V Technology has introduced the Meles SBC, a credit card-sized single-board computer (SBC) equipped with a T-Head TH1520 quad-core RISC-V processor. Designed with a form factor similar to the Raspberry Pi 3 Model B, this board offers enhanced performance and a wide...

Continue Reading
1.182
Views
0 Comments
DC-ROMA RISC-V Laptop II with SpacemIT K1 Octa-Core SoC to Run Ubuntu Supported by Canonical
MiscellaneousTop Stories

DC-ROMA RISC-V Laptop II with SpacemIT K1 Octa-Core SoC to Run Ubuntu Supported by Canonical

Deep Computing has announced the DC-ROMA RISC-V Laptop II, which is powered by a 2.0 GHz SpacemIT K1 octa-core 64-bit RISC-V processor, coupled with up to 16GB of DDR4 memory, and runs Ubuntu with official support from Canonical. In 2022, Deep Computing unveiled the first RISC-V laptop...

Continue Reading
1.185
Views
0 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives