Tag Archives: MP3

MP3 player using Arduino and DFPlayer mini

Hi guys, welcome to this tutorial. Today, we will build an mp3 player using an Arduino and the DFPlayer mini MP3 module.

The DFplayer mini is a small, low-cost mp3 module with a simplified audio output that can be connected directly to a speaker or an earphone jack. The module can be used as a stand-alone module with attached battery, speaker, and push buttons or used in combination with a microcontroller or development board like the Arduino, enabled for RX/TX (Serial) communication, thus through simple serial commands we can play music and perform other functions like playing the next and previous song, shuffle, pause the song currently being played etc. The module comes with an SDcard slot and supports both FAT16, FAT32 file system.

MP3 player using Arduino and DFPlayer mini – [Link]

MP3 Module & RTC DS1307 Shield For 28/40 Pin PIC Development Board

MP3 Shield has been designed for various applications related to voice record and play using MP3 module with memory card storage, this shield can be used as standalone mode or Digital mode by serial interface. In standalone mode it can play 16 messages with couple of other functions, Standalone operation possible by connecting resistors and push switches on ADC pins of the module check data sheet for switch connections. Digital mode provides full control of messages with serial interface. Shield also has DS1307 RTC on board to develop a taking clock or other time related applications. Board has dual audio outputs, single channel 3W direct speaker output from MP3 Module and On board 5W Stereo Amplifier based on BA5406 provided to Amplify low audio signal coming from MP3 module. 4 Tact switch with open header connector can be interface to any port of micro-controller using female to female wire harness. RC6, RC7 and RC5 pin connected to micro-controller for serial interface. DS1307 RTC pins are connected to RA0 and RA1 Port pins. Refer to datasheet for Module Serial Interface, switch connections circuit for stand-alone mode.

MP3 Module & RTC DS1307 Shield For 28/40 Pin PIC Development Board – [Link]

Arduino Project: MP3 player using Arduino and DFPlayer mini MP3 player module

Building an MP3 player with Arduino is extremely easy. We use the DFPlayer mini in order to build a simple MP3 player. The MP3 player has 3 buttons, in order to Play/Pause, to load the next song and one in order to load the previous song. In this video we are using an Arduino Uno, but you can use any Arduino board you like.

Arduino Project: MP3 player using Arduino and DFPlayer mini MP3 player module – [Link]