Month: June 2016

Tiny Bar-Graph current meter displays a Red color bright, easy to read display of current range from 0 to 1A.  This Bar-Graph has 20 segments in single color and display 0 to 1Amp Current. The Barograph current monitor is based on PIC microcontroller with 10 Bit resolution ADC. ...

by LightBug @ instructables.com: In today's instructable I'm going to show you how to build your own electromagnetic field meter using an Arduino. This device can be used to detect mains voltage, static electricity and radiations from certain devices. Electromagnetic Field Detector...

Elektor is more than a magazine, it is a community of active electronic engineers eager to learn, make, design and share surprising electronics. If you would like to join this community by purchasing a yearly membership you may consider this exclusive offer. Elektor, offers 50%...

This is an intriduconary article about PCBs and their uses. In this instructable, I'll go over what a printed circuit board is, where they are used, and the basics of how to make one yourself. So sit back, strap in, and enjoy learning about this very important and interesting method...

thirschbuechler @ instructables.com shows us how to build a 1GHz active probe using BF998 dual-gate MOSFET and some other RF components. This Instructable will show you how to build a 1GHz* Fet-based Active Probe, the Fetprobe, for about 10$*, provided you have access to an...

Linear Technology Corporation announces the LTC3895 , a high voltage non-isolated synchronous step-down switching regulator controller that drives an all N-channel MOSFET power stage. Its 4V to 140V (150V abs max) input voltage range is designed to operate from a high input voltage...

Mare shares his sensor board based on MS5637 HDC108. He writes: This is another small module to measure air pressure, temperature and humidity. Two sensors are on-board: MS5637 and HDC1080. Microcontroller is small cortex M0 in TSSOP-20 housing from STM: STM32F070CxP. The...

Jason Jones has been working on a curve tracer project and shows us his June progress: As the hardware is at the point of initial release, but the firmware and GUI aren’t quite there yet, I decided that it would be prudent to split off the firmware and GUI components into their own...