Tag: IGBT

High-Voltage Half-Bridge Board with Adjustable PWM Signal Generation
The high-voltage half-bridge board features a 2ED2184 half-bridge gate driver, 2 x IKW20N60H3FKSA1-ND IGBTs, and an SG3525 PWM signal generator. This board is designed to support bus supplies of up to 400V DC, PWM frequency up to 6.5Khz and adjustable duty cycle range 2% to 98% making...
Continue Reading
Half-Bridge with Over Current Protection – 400V/1A
The Half-Bridge Driver project presented here is designed to support load power supplies of up to 400V DC. The board features the IRS2890DS Half-Bridge Gate Driver IC, which is paired with two IGBTs rated at 8A/650V, conveniently mounted on the board. The board features overcurrent...
Continue Reading
Half-Bridge Driver Module – 48V/5A Load
This Half-Bridge Driver Module is a low-voltage power management solution designed to drive a wide range of applications, including DC motors, DC-DC converters, and other inductive and resistive loads. The module is engineered to operate within a load supply voltage range of up to 48V...
Continue Reading
Ingition Coil Driver
The project presented here is an Ignition coil driver featuring FAN1100-F085 ignition gate driver chip and IGBT. Chip is designed to directly drive an ignition IGBT and control the current and spark event of the coil. The coil current is controlled via the input signal pin. When the...
Continue Reading
1200V Inverter Module for 3 Phase Motors up to 2KW
The power board described here is designed for motor applications, featuring the 6ED2230S12T gate driver IC and FP15R12W1T4 IPM power module from Infineon. It provides an AC input and a 3-phase power output, with a single emitter shunt for current sensing and a voltage divider for...
Continue Reading
3-Phase Advance Motion Module – 400VDC – 4A
This is an advanced Motion module providing a fully featured, high-performance inverter output stage for AC induction, BLDC and PMSM motors such as refrigerators, fans, and pumps. This module is based on NFA50460 chip which integrates the optimized gate drive of the built−in IGBTs...
Continue Reading
1200V High-Current Half-Bridge using FAN73912
The project presented here is designed for high-voltage and high-speed driving for MOSFETS and IGBTs that operate up to +1200V. The project consists of a FAN73912 gate driver chip and 2 x IGBTs, DC bus capacitors, current sense resistor for current feedback etc. The advanced input...
Continue Reading
600W – 230VAC – High Voltage DC Motor Speed Controller – Heater Controller – Lamp/LED Dimmer
This is a very powerful DC Motor speed controller for DC motors up to 330V DC and current up to 2A. Basically, the project is a high voltage PWM source with adjustable frequency and adjustable PWM duty cycle range 0 to 99%. The board has been designed considering many applications...
Continue Reading