Home Blog  





7 Sep 2011

Using VFD display with Arduino – [via]

Summer of 2010 I picked up an Arduino board from adafruit and took some time to walk through all of the tutorials available with it. Since then I have spent most of my time on other projects including my bachelor’s. Recently I have obtained the Motor Party Pack, LoL Shield Kit, and a 20×2 VFD (Vacuum Fluorescent Display) to go with the original board so my interest is sparked again. I have found that the Motor Party Pack and LoL Shield have adequate instruction and tutorials, but the VFD is lacking in beginner level instructions to get started. As such I have decided to write a tutorial for the 20×2 VFD available through adafruit.

The adafruit VFD is made by Samsung and is model No. 20T202DA2JA, this is really unimportant though as adafruit is nice enough to link you to the spec sheets for both the module and the controller chip. What you would be looking for is the pin-out found on page 4 of the module controller sheet.

Using VFD display with Arduino - [Link]

Leave a Reply

You must be logged in to post a comment.



 
 
 

 

 

 

Search Site | Advertising | Contact Us
Elektrotekno.com | Free Schematics Search Engine | Electronic Kits