This is an easy-to-make LED dimmer using RF remote control. The project is capable of driving a load up to 24W (2A X 12V LED). Any 12V single or 12V LED strip can be used. This is an open-source Arduino compatible hardware that has Atmega328 microcontroller, Potentiometer, MOSFET, 5V Regulator, 3.3V Regulator, NRF24L01 Radio modules, and few other components. The same PCB can be used for Transmitter and Receiver. LED D2 Power LED, LED D1 optional.
Radio Remote Control LED Dimmer Using NRF24L01 – Arduino Compatible – [Link]
View all comments
Join 97,426 other subscribers
Aaeon AI Arduino ARM Battery BLE Bluetooth camera DC-DC display ESP32 ESP8266 FPGA GPS I2C IoT Kickstarter LCD Led Linux Mcu MEMS Microchip Microcontroller MOSFET Motor OLED Oscilloscope PCB Power supply PWM Raspberry Pi regulator RISC-V SBC Sensor SOC SOM STMicroelectronics Switching temperature Texas Instruments TFT USB Wifi